Can-Am SPYDER RT Series 2020, Original Instructions Manual

Page: 130 / 203

MAINTENANCE PROCEDURES
126
Note: Replacing brake pads will in-
crease brake fluid level. If replaced
when at MAX level, brake fluid spills
may occur.
NOTICE Brake fluid can damage
painted surfaces or plastic parts. Wipe
up any spills.
4. Reinstall filler cap and lock in
place.
5. Reinstall the service cover.
Verifying the Brake System
The front and rear brakes are hydraulic
disc types. These brakes are self-ad-
justing and do not require adjustment.
The brake pedal also requires no ad-
justment.
To keep brakes in good condition,
check the following as per the
MAINTENANCE SCHEDULE :
- Entire brake system for fluid leaks
- Brake pedal for spongy feel
- Brake discs for excessive wear and
surface condition
- Brake pads for wear, damage or
looseness.
See an authorized Can-Am On-Road
dealer if there are any problems with
the brake system.
Headlights
Verifying the Headlights Aiming
1. Verify tires are correctly inflated.
Refer to the T
IRES
P
RESSURE
L
ABEL
located under the driver's
seat..
2. On base models, set the rear sus-
pension air pressure to the cor-
rect loading condition (refer to
the
R
EAR
S
USPENSION
P
RESSURE
LABEL
locacated also under the
driver's seat).
Note: For Limited models, the com-
pressor levels the vehicle automati-
cally.
3. Position vehicle in front of a test
surface as shown. Make sure vehi-
cle is on leveled ground.
A
90°
219002072-082
A. 10 m (33 ft)
90°
219002072-083
Trace 2 lines parallel to the ground on
the test surface as follows: