Can-Am SPYDER RS, Operator'S Manual, Page: 118 / 147

MESSAGES IN MULTIFUNCTION GAUGE CLUSTER
Important information about vehicle condition is displayed on the multifunction
gauge cluster. When starting the engine, always look at the gauge cluster for any
special messages.
If a fault is displayed, press the MODE button to skip the error message.
If a problem persists, go to an authorized Can-Am roadster dealer.
INDICATOR
LAMP(S)
MAIN
DIGITAL
DISPLAY
CAUSE WHAT TO DO
None
Gearbox
position
sensor
malfunction
Have the vehicle repaired by an
authorized Can-Am roadster dealer.
E displayed
instead of
selected gear
N + R flashing
quickly
Undetermined
gear position
Stop vehicle and allow to reach
neutral.
None BAD KEY
Wrong or
defective key
Use the right key for the vehicle
or contact an authorized Can-Am
roadster dealer.
On HI TEMP
Engine is
overheating
– Stop and wait for engine to
cool off.
– Check for leaks.
– Check coolant level and
adjust (see ENGINE COOLANT
LEVEL VERIFICATION ).
On
HI TEMP
LIMP HOME
Engine is
overheating
* Have the vehicle transported to the
nearest authorized Can-Am roadster
dealer.
On LO BATT VOLT
Low battery
voltage
– Recharge battery (see
BATTERY
CHARGING
).
– Check battery connections.
On HI BATT VOLT
High battery
voltage
Have the vehicle transported to the
nearest authorized Can-Am roadster
dealer.
ABS
On ABS FAULT
ABS
malfunction.
No ABS
operation
Have the vehicle transported to the
nearest authorized Can-Am roadster
dealer.
On
VSS FAULT
LIMP HOME
VSS
malfunction
* Have the vehicle transported to the
nearest authorized Can-Am roadster
dealer.
On
SEAT SWITCH
DEFECTIVE
Defective
pillion rider
seat switch
Check fuse (see FUSES ).
116
______________