Can-Am Outlander X mr Series, Operator'S Manual

Page: 105 / 196

SPECIAL PROCEDURES
What to Do if Water is in the
CVT
The CVT drain plug is located on the
rear portion of the CVT cover. It is ac-
cessible from the rear LH fender.
Inspect the CVT drain plug to validate if
water is present.
vmo2013-014-009_a
NEAR LH FOOTREST
1. Drain plug
2. Spring clamp
NOTICE
If water entered your CVT
while in a muddy environment, limit
vehicle usage and bring your vehicle
to your nearest authorized Can-Am
dealer for a proper CVT cleaning
procedure.
If water is present, remove CVT drain
plug to expel water.
Reinstall the drain plug and secure it
using the spring clamp.
NOTE: Make sure drain plug is prop-
erly inserted on CVT cover nipple.
NOTICE
See an authorized
Can-Am dealer to have the CVT in-
spected and cleaned.
What to Do if Water is in the
Air Filter Housing
Inspect the drain reservoirs in the back
of the front left wheel inner fender to
validate if water is present.
vmo2013-009-035_a
TYPICAL
1. Clean air filter housing drain reservoir
2. Dirty air filter housing drain reservoir
If water is present, press clamps and
remove reservoirs to drain water from
air filter housing.
If one of the following conditions is
met, bring the vehicle to your nearest
authorized Can-Am dealer to have the
vehicle serviced:
– If more than 50 ml (2 U.S. oz) of
water (approximately 5 drain reser-
voirs) is found in the clean chamber
drain hose.
– If any deposits are present in the
clean chamber drain reservoir.
– If either hose is obstructed.
In such a case, the vehicle must be ser-
viced for:
– Air filter housing cleaning
– Vents (radiator cooling fan, water
pump, coolant reservoir, fuel tank,
gearbox, front differential and rear
final drive)
– CVT air filter cleaning
______________
103