Can-Am MAVERICK Trail 2021 Series, Operator'S Manual

Page: 76 / 195

7.6" DIGITAL DISPLAY
219002049-302
1. DRIVE MODE button
2. MENU button
3. OK button
4. TRIP button
Maintenance Reset
NOTE: Only when the maintenance
icon is displayed.
Using MENU button, select RES
MAINT and hold to reset maintenance.
Fault Codes
NOTE: Only when fault codes are ac-
tives.
Using MENU button, select CODES
and hold to see active fault codes.
Fault codes will be scrolled on the
Lower Display.
Reset Stats
Using MENU button, select RESET
STAT and hold to reset.
Unit Selection
This multifunction gauge is factory pre-
set in Imperial units but it is possible to
change it to Metric units.
Using MENU button, select UNITS
and hold button to change units.
Speed/RPM
The speed and RPM display can be
swapped.
Using MENU button, select
SPEED/RPM and hold button to
invert speed and RPM display.
Setting Clock
Using MENU button, Select CLOCK
and hold to change time.
1. Press MENU button to select clock
display.
2. Push and hold MENU button for 1
second.
3. Press MENU button to select 12:00
AM PM or 24:00 time base.
4. Push and hold MENU button or OK
button to acknowledge selection.
5. Press MENU button to change
hours (hours flash).
6. Push and hold MENU button or OK
button to acknowledge hour selec-
tion
7. Press MENU button to change min-
utes (minutes flash).
8. Push and hold MENU button or OK
button to acknowledge minute se-
lection.
Setting Brightness
The brightness of the LCD display can
be adjusted.
Using MENU button, select BRIGHT-
NESS and hold MENU button to select
the brightness setting.
Using MENU button, adjust brightness
then push and hold MENU button to ac-
knowledge selection.
Setting Language
The gauge display language can be
changed.
Refer to an authorized
Can-Am dealer for language availability
and to setup the gauge to your prefer-
ence.
74
______________