Can-Am MAVERICK Sport MAX T, Operator'S Manual

Page: 122 / 187

MAINTENANCE PROCEDURES
219002003-017
1. Spark plug
Clean spark plug area with pressurized
air before removing spark plug.
Unscrew spark plug completely using
a spark plug socket, then remove it.
Spark Plug Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug is free of grime.
Using a feeler gauge, set the spark plug
gap.
SPARK PLUG GAP
0.8 mm to 0.9 mm (.031 in to .035 in)
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads.
Screw spark plug into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
NOTICE
Do not overtighten spark
plugs, engine damage can occur.
TIGHTENING TORQUE
Spark plug 11 N•m (97 lbf• in )
CVT Cover
NOTE: For a better understanding,
some illustrations are taken with en-
gine out of vehicle. To perform the
following instructions, it is not neces-
sary to remove engine.
This CVT is lubrication free. Never lu-
bricate any components except drive
pulley bearing.
WARNING
Never touch CVT while engine is
running. Never drive vehicle when
CVT cover is removed.
WARNING
Engine must be cool before cover
is removed. Always wear protec-
tive gloves when removing cover.
Place the vehicle on a level surface.
Select PARK position.
CVT Cover Access
The CVT cover is located on the LH side
of the vehicle.
219002003-018
1. CVT cover
CVT Cover Removal
Remove CVT air intake hose.
120
______________