Can-Am MAVERICK Sport MAX T, Operator'S Manual

Page: 117 / 187

MAINTENANCE PROCEDURES
3. Install pressure cap.
4. Run engine at idle with the pressure
cap ON until the cooling fan cycles
on for a second time.
5. Stop the engine and let it cool down.
WARNING
In order to avoid potential burns,
do not remove the pressure cap if
the engine is hot.
6. When the engine is cool, remove
pressure cap and add coolant if re-
quired.
7. Install pressure cap.
8. After the next ride, recheck the
coolant level and refill if necessary.
Muffler and Spark Arrester
Muffler Spark Arrester Cleaning and
Inspection
CAUTION Never perform this
operation immediately after the en-
gine has been running as exhaust
system is very hot.
Remove and discard the tail pipe retain-
ing bolts and nuts.
219002008-002
1. Tail pipe retaining screws
Remove spark arrester.
219002008-003
1. Tailpipe
2. Gasket (discard)
3. Spark arrester
4. Screw
Remove carbon deposits from the
spark arrester using a brush.
NOTICE
Use a metallic soft brush
and be careful to avoid damaging
spark arrester mesh.
tmo2011-001-043_a
1. Clean spark arrester
Inspect mesh of spark arrester for any
damage. Replace as required.
Inspect spark arrester chamber in muf-
fler. Remove any debris as required.
Reinstall the muffler spark arrester us-
ing a new gasket.
TIGHTENING TORQUE
Tailpipe retaining
screw
32 N•m ± 2 N•m
(24 lbf•ft ± 1 lbf•ft)
______________
115