Can-Am DS 70, Operator'S Manual, Page: 96 / 132

MAINTENANCE PROCEDURES
vmo2008-008-048_a
1. Drive chain roller
Sprocket and Pinion Inspection
Check the sprocket axle and pinion for
distortion. Replace if necessary.
V02H02Y
1
2
1. Good
2. Replace
CAUTION Replace chain,
sprocket axle and pinion together
to prevent rapid chain and sprock-
et wear. Install a new retaining ring
each time the pinion is removed.
Wheels and Tires
Tire Pressure
WARNING
Tire pressure greatly affects ve-
hicle handling and stability. Low
pressure may cause tire to deflate
and rotate on wheel. Overpres-
sure may burst the tire. Always
follow
recommended pressure.
Since tires are low-pressure types,
a manual pump should be used.
Check pressure when tires are cold
before using the vehicle. Tire pres-
sure changes with temperature and
altitude. Recheck pressure if one of
these conditions has changed.
For your convenience, a pressure
gauge is supplied in tool box.
TIRE PRESSURE
FRONT AND REAR
MINIMUM
25 kPa (3.5 PSI)
MAXIMUM
35 kPa (5 PSI)
Although the tires are specifically de-
signed for off-road use, a flat may still
occur. Therefore, it is recommended
to carry a tire pump and a repair kit.
Tire/Wheel Condition
Occasionally, wheel bolts should be
removed to apply anti-seize lubricant
to ease future removal. This is particu-
larly important when vehicle is used in
salt-water environment or in mud. Re-
move one nut at a time, lubricate then
retorque.
Check tires and rims for damage and
wear.
Replace if necessary.
94
______________________