Can-Am DS 450 2008, Shop Manual

Page: 47 / 401

Section 03 ENGINE
Subsection 02 (AIR INTAKE SYSTEM)
vmo2008-011-020_a
1. Air filter housing
2. Drain tube
3. Clamp
NOTE: If vehicle is used in dusty area, inspect
more frequently than specified in MAINTENANCE
CHART .
If liquid/deposits are found, squeeze and remove
the clamp. Pull drain tube out then empty it.
CAUTION: Do not start engine when liquid or
deposits are found in the drain tube.
When liquid/deposits are found, the air filter must
be inspected and dried or replaced depending on
its condition.
NOTE: After air filter installation, you can find a
small quantity of air filter oil in the drain tube.
Air Filter Housing Removal
Remove seat.
Remove the front body assembly. Refer to
BODY
section.
Remove battery. Refer to
CHARGING SYSTEM
section.
Disconnect all wires from the starting solenoid.
Refer to
STARTING SYSTEM
section.
Remove plastic rivet securing the air intake hose
deflector.
vmr2008-010-002_a
1. Air intake hose
2. Deflector
3. Plastic rivet
Cut locking ties holding air intake hose and
crankcase vent tube.
vmr2008-010-006_a
1. Air intake vent hose
2. Crankcase vent tube
Loosen clamp securing air intake hose to throttle
body.
vmr2008-010-003_a
1. Air intake hose
2. Clamp
3. Throttle body
Underneath rear fender, remove screws securing
air filter housing to rear frame extension.
vmr2008-010
27