CPB-515 Operation and Maintenance Manual – TTS 70, 80,100, 110 Series (10-2021)
15
7.
Lightly grease machined surface of center pivot pin and insert into the receiver end
of the axle. Rotate the pin to align the rear mounting hole in the receiver pin.
Install the bolt and locknut provided with the kit. Tighten pin bolt and lock nut to
130Nm (96 ft-lbs).
8.
Install the inner thrust washer against the axle pin flange.
9.
Apply a light amount of grease to the center pivot pin.
10.
Slide the undercarriage onto the axle pin. NOTE: Care must be exercised to avoid
damage to the lip seals on the center bore of the undercarriage assemblies during
installation. Using a fork truck, lift the undercarriage assembly onto the center pivot
pin.
WARNING
Make sure undercarriage is installed with track tensioner assembly
(spring) positioned to the rear of implement. DO NOT install the
track system with the tensioner positioned to the front of the
implement.
Grease this
surface