After turning the key in the ignition switch to the "I" position, they
should the four LEDs on the internal panel light up (STATUS NVR,
HDD and NVR power supply, MAIN power supply, IP CAMERA power
supply).
Wait about 1 minute, then check the configuration of the recorder,
wireless connection and IP camera, and correct the settings if ne-
cessary. Detailed information can be found later in this manual.
To turn off the device, turn the ignition key to the "0" position.
3.4. Closing the device cover
Close the housing of the device paying special attention to the arrangement of the cables
and the battery. Tighten all screws securely so that the housing is completely sealed.
The device is ready for installation at its destination.
3.5. Installation at destination / monitored place
The set (iCAM-Mobile with an IP camera) should be mounted only to solid, stable wall
and mast structures. The installer is responsible for the correct installation of the came-
ra!
Items that should be mounted in the selected place:
Bracket adapter with wall anchors - for wall mounting
Bracket adapter with steel straps - for pole mounting.
WARNING
The handle should be mounted vertically, the place for the
padlock must be at the bottom. The installer is responsible for
the correct installation of the camera in accordance with these
instructions and safety standards!
In addition, a steel safety cable must be fitted to a separate anchor
or other part of the pole. The safety cable should be mounted to a
solid, solid construction that will guarantee the maintenance of the
iCAM-Mobile system with the camera in case of emergency.
Slide the camera (antennas upwards) into the holder, then attach the
security cable and secure the camera with a padlock.
Page 11
