Campomatic WD13TX, User Manual

Page: 20 / 36

EN - 17
• Place each item of laundry in separately.
• Check that no items of laundry are
trapped between the rubber seal and
the door.
• Make sure that the door is completely
closed or the machine won’t start the
washing operation.
6.4. Choice of Detergent and
Placing Into the Machine
The amount of detergent to use will depend
on the dirtiness of your clothes and the
hardness of your water supply; guidelines
will be on the packaging of your detergent.
• If your clothes are only slightly soiled,
do not do a pre-wash. Put a small
amount of detergent (as specified by the
manufacturer) into compartment II of the
detergent drawer.
• If your clothes are excessively soiled,
select a programme with pre-wash and
put ¼ of the detergent to be used into
compartment I of the detergent drawer
and the rest in compartment II.
• Use detergents produced for automatic
washing machines in your machine.
Follow the instructions on the detergent
packaging when determining the
amount of detergent to use for your
laundry.
• The higher the degree of hardness of
the water, the more detergent you will
need.
• The amount of the detergent you will
use will increase as the amount of your
laundry increases.
• Put the softener in the softener
compartment in the detergent drawer.
Do not exceed the MAX level, otherwise
the softener may flow into the washing
water.
• Softeners with high density must be
thinned before being put in the drawer.
High-density softener will clog the flush
and block the flow of the softener.
• You can use liquid detergent in all
programmes without pre-washing.
Insert the liquid detergent apparatus in
compartment II of the detergent drawer
and adjust the liquid detergent amount
(follow the instructions on the liquid
detergent packaging). Do not exceed
the MAX level..
6.5. Programme Selection
Turn the dial to select the desired washing
programme.
7. Additional Functions
To allow you to get the best washing results
possible, your machine offers the following
additional functions to complement the
selected programme. To select an additional
function before starting a programme:
• Press the button on the Control Panel
below the symbol of the additional
function you wish to select.
• If the symbol of the additional function
flashes continuously, the function has
been activated.
• If the symbol of the additional function
blinks, the function has not been
selected.
• Reason for non-activation:
• The additional function is not
compatible with the selected