Campomatic WD13TX, User Manual

Page: 16 / 36

EN - 13
NOTE:
Operating your machine
with low voltage will cause the life cycle
of your machine to be reduced and its
performance to be restricted.
4.4. Water Inlet Connection
3/4”
10 mm
1
3
2
4
• Connect your Washer Dryer to your cold
water supply only.
• Only use the water inlet hose supplied
with your machine or one purchased
through an authorised dealer.
• A gasket is included in the hose
packaging to prevent water leaks from
connections. Fit this gasket to the
end of the water inlet hose that will be
connected to the tap.
• Connect the angled end of the water
inlet hose to the cold water inlet on the
rear of the machine and hand-tighten.
• Screw the other end of the water inlet
hose onto a 3/4” water tap and hand-
tighten.
• If in any doubt, consult a qualified
plumber.
• Turn the cold water supply on and check
for any leaks.
• Water flow with pressure of 0.1-1 Mpa
will allow your machine to operate at
optimum efficiency (pressure of 0.1
Mpa means that more than 8 litres of
water per minute will flow through a fully
opened tap).
• Ensure that the the hose is not trapped,
kinked, twisted, folded or crushed.
NOTE:
Only use the water inlet
hose supplied with your machine when
making connections. Never use old, used or
damaged water inlet hoses.
4.5. Water Draining Connection
• Connect the water drain hose to a
standpipe or to the outlet elbow of
a household sink, using additional
equipment. The hose must be placed
between 0 cm and 80 cm from the
ground.
• Never attempt to extend the water drain
hose.
• Do not put the water drain hose from