1
21
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
(844) 538-7475
Before Operate The Drain Plug, Must be
1. Ensure that the water heater is disconnected from the gas supply.
2. Ensure that the water heater is disconnected from the water supply (turn off
cold water inlet switch).
3. Turn the shower switch to “ON”.
4. Ensure that the shower hose is disconnected from the water heater.
Adjustment
The temperature of the outgoing water is dependent on the temperature of the
incoming water balanced with the amount of heat applied. Use extreme caution in
setting the outlet water temperature.
1. With the water knob set to Max, and the gas knob set to Min, feel the outgoing
water. This is the lowest setting available.
2. To initially raise the outgoing temperature, slowly turn the gas valve towards
maximum. Adjust slowly and check the temperature often. There will be a
slight delay between increasing the gas supply and the increase in water
temperature.
Common Issues With Solutions
Water pressure too high
Water pressure too low
Low battery
Over heat protection
If water pressure is over 110 PSI/760
kPa, the water-out valve will release
water and lower the pressure
If water pressure is below 3.6 PSI/25
kPa,the water heater cannot be ignited
The power of battery will become less
after use for some time, thus the water
heater cannot be ignited
Water heater automatically shuts off
when water temperature is 125ºF
(52ºC)
Increase the valve pressure limit
according to local water supply
pressure
Use the water heater later when
pressure becomes higher
Change Batteries
Re-start water heater later when
water becomes cooler
Issue Indication Solution