12
www.camplux.com
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Very hot while in a operation!
Never lean over the fireplace while in use.
Do not touch tile of spark guard while the fire table
is in operation, wait until the fire table has cooled
down after use.
Failure to comply with these instructions may
result in serious bodily injury.
WARNING
● CARBON MONOXIDE HAZARD.
● For outdoor use only. Never use inside house, or
other unventilated or enclosed areas. This fire
table consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
DANGER
●
Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water).
●
Apply several drops of solution where hose attaches to regulator.
●
Apply several drops of solution where regulator connects to cylinder.
●
Make sure all fire table and light valves are OFF.
●
Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
●
Turn cylinder valve OFF.
●
If leak is at hose/regulator connection: tighten connection and perform another leak test. If bubbles continue
appearing, the hose should be returned to the place of purchase.
●
If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another leak check. If you
continue to see bubbles after several attempts, cylinder valve is defective and should be returned to cylinder’s
place of purchase.
If NO bubbles appear at any connection, the connections are secure.
Note:
Whenever gas connections are loosened or removed, you must perform a complete leak test.
Complete installation.
Caution:
Do not attempt to operate until you have read and understand all General Safety Information in this
manual and all assembly is complete and leak checks have been performed.
Before turning gas supply ON:
● Your fire table was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any
other enclosed area.
● Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.
● Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no leaks.
● Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
Before lighting:
● Fire table should be thoroughly inspected before each use, and by a qualified service person at least annually.
If relighting a hot fire table, always wait at least 5 minutes.
● Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly
specified by manufacturer.
● Check and ensure that an AA battery (not included) is inside the ignition chamber and has power. Ensure the
anode (+) faces outside (Figure d).
