Before operate the drain plug
,
must be
1
.
Ensure that the water heater is disconnected from the gas supply
.
2
.
Ensure that the water heater is disconnected from the water supply
.
3
.
Ensure that the shower hose is disconnected from the water heater
.
Adjustment
The temperature of the outgoing water is dependent on the temperature of the incoming
water balanced with the amount of heat applied
.
Use extreme caution in setting the outlet
water temperature
.
1
.
With the water knob set to high
,
and the gas knob set to low
,
feel the outgoing water
.
This is the lowest setting available
.
2
.
To initially raise the outgoing temperature
,
slowly turn the gas valve towards maximum
.
Adjust slowly and check the temperature often
.
There will be a slight delay between
increasing the gas supply and the increase in water temperature
.
3
.
Should the outlet water temperature need to be higher
,
slowly reduce the water flow
knob until desired temperature is reached
.
(
Warning
:
Do not alter or change this water heater
’
s original temperature sensor
)
WARNING
:
THE PORTABLE TANKLESS WATER HEATER IS CAPABLE OF
PRODUCING SCALDING WATER TEMPERATURES
!
Following Phenomena Are Not Real Troubles
Protective function
Reaction
Remarks
Water pressure too high
If water pressure is over 110PSI
,
the
water
-
out valve will release water
and lower the pressure
Increase the valve pressure
limit according to local water
supply pressure
Water pressure too low
If water pressure is below 2
.
8PSI
,
the water heater cannot be ignited
Use the water heater later
when
pressure
becomes
higher
