Do not use charcoal as a substitute for, or in addition to, lava rock.
Do not use an adjustable low pressure regulator.
Do not cover the bottom of the base with aluminium foil.
Never put a metal plate, that has neither been designed nor recommended by CAMPINGAZ,
on (or in the place of ) the lava rocks.
Follow these instructions carefully to avoid seriously damaging your barbecue.
France (depending on model),Belgium, Luxembourg,
Netherlands, United Kingdom, Ireland, Poland,
Portugal, Spain, Italy, Czech and Slovak Republics,
Norway, Sweden, Denmark, Finland:
The barbecue is equipped with a circular connector. It should
be used with flexible hose UK that is suitable for use with butane
and propane gas. hose UK length should not exceed 1.2 meters
and should be changed whenever it is damaged or cracked.
Do not pull or pierce the hose UK. Keep away from any parts
of the barbecue that get hot.
Switzerland, Germany,Austria:
The barbecue should be used with flexible tubing that is
suitable for use with butane and propane gas. Tubing length
should not exceed 1.2 meters and should be changed
whenever it is damaged or cracked. Do not pull or pierce the
tubing. Keep away from any parts of the barbecue that get
hot.
Flexible tubing connection. To connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
provided:
- no. 14 wrench to tighten the connector
- no. 17 wrench to tighten the nut on the tubing
e) Lid
(depending on model)
Handle the lid carefully, especially during operation. Do not lean
over the base
f) Checking for gas leaks
1) Work outside, away from all sources of ignition. Do not smoke.
2) Make sure the control knobs are in the "off" (
l
) position.
3) Push the end of the hose completely onto the regulator
nozzle and secure with a suitable clip.
4) Fit the regulator onto the gas cylinder in accordance with its
instructions.
5) Use a gas leak solution to test for leaks.
Important:
never
use a naked flame to check for gas leaks.
6) Apply the solution to the connections cylinder/regulator/
hose/apparatus (the control knobs should remain closed: off
position). Open the gas cylinder valve.
7) Bubbles in the gas leak solution indicate that there are gas
leaks.
Operation and maintenance
a) For your safety
- Do not store or use petrol and other flammable liquids or
vapours in the vicinity of this barbecue. If you smell gas:
1) Close the valve of the cylinder
2) Extinguish all naked flames
3) Open the lid
4) If the smell continues , see F or immediately seek advice from
your local retailer.
b) Location
- This barbecue must only be used outdoors.
-
Caution:
accessible parts may get very hot. Keep young
children away.
- There should be no combustible materials within a radius of
approximately 60 cm around the barbecue
- Do not move the barbecue when alight.
- The appliance should be operated on a level surface.
- Estimated air offtake 2 m
3
/kW/h.
c) Gas cylinder
- This barbecue has been adjusted to be operate off 4,5 to 15 kg
butane/propane cylinders with an appropriate low pressure
regulator (butane 28 mbar / propane 37 mbar).
- Always connect or replace the cylinder in a well-ventilated
area, never in the presence of a flame, spark or heat source.
d) Hose
France (depending on model):
The unit is equipped with a G1/2 threaded inlet coupling. A
circular connector and rubber gasket are also supplied for the
butane/propane bottle.
Depending on the construction of your regulator, follow these
instructions:
1) For regulators equipped with an M20 x 1.5 threaded
outlet: Use reinforced flexible tubing that complies with the XP
D 36112 standard. Screw the G1/2 tubing coupling onto the
connector on the barbecue. Screw the M20 x 1.5 threaded
connector onto the regulator outlet.Test the seal with gas leak
solution.
2) For regulators equipped with a circular coupling: Use a
connector assembly (flexible collars) that complies with
the XPD 36110 standard. Screw the circular coupling supplied
with the unit to the threaded connector, inserting the rubber
gasket between them. When the gasket is in contact with the
connector, tighten approximately one half turn.
Connect the flexible tubing to the coupling on the barbecue and
the connector on the regulator by following the instructions
supplied with the connector assembly (couplings).
Test the seal with gas leak solution.
Make sure the flexible tubing is not twisted or under stress,
and does not come into contact with any hot surfaces on the
unit.The length of the tubing should not exceed 1.2 meters and
should be changed by the expiration date printed on the tubing
or whenever it is damaged or cracked.
6
GB
Gb.qxp 08/06/2004 08:50 Page 1
Summary of Contents for Eldorado 2 Super
Page 1: ...N 072181...
