29
OPERATING INSTRUCTIONS
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY.
●
DO NOT
allow gasoline or other flammable vapors or liquids to come in contact with stove while
lighting or at any time during use of stove.
●
DO NOT
allow the gas hose to came into contact with any hot surfaces. Inspect the hose tor
damage such as burns, chafing, and kinks before each use.
WARNING
There are 3 positions for the control knobs, as
indicated on the appliance:
Reduced flow rate
(smaller flames)
Full flow rate
(bigger flames)
OFF
Step 1
Make sure “
Gas Leak Testing
” from page 5
was completed and the burner control knobs
are in the ‘OFF’ position and stove is an a flat
surface away from combustible material.
Step 2
Decide which burner to light first. Using a long
match, hold the flame beside burner. Turn the
burner control knob to the full flow rate position
until the burner lights.
WARNING:
If the burner does not light within
5 seconds, turn the burner control
knobs “OFF” immediately. Wait at
least 5 minutes until gas fumes
have dissipated before attempting
to light burner again.
Step 3
To light the second burner, turn the knob of the
first burner to the reduced flow rate position
and repeat Step 2 to the other burner.
WARNING:
If second burner does not light
within 5 seconds, turn the burner
control knobs “OFF” immediately.
Wait at least 5 minutes until gas
fumes have dissipated before
attempting to light burner again.
Step 4
Adjust burner flame as necessary by using
burner control knob. Turn stove “OFF” using
burner control knobs when stove is not in use.
Step 5
Allow stove to cool completely, then
follow instructions in the “After-Use
Safety’’and”Proper Care & Maintenance”
sections of this manual.
Minimum clearance to combustibles 90 cm
from top and side of stove burners
90 cm
90 cm
Perimeter of base of stove
GB
EN
IS
FOR
R
EFERENCE
.
DO
N
OT