Campbell RF401A Series, Instruction Manual

Page: 28 / 52

RF401A-Series Spread Spectrum Radio
16
9.2 Using a Repeater
When using an RF401A-series radio as a repeater in your network, it can be
entered into the LoggerNet Setup screen using the pbRouter device and
entering the PakBus® address of the RF401A series in the PakBus Address
field. If the repeater is the first hop from
LoggerNet
, it should always be shown
in the network map. This will force routes to go through the repeater. If the
repeater is further down the network, it may still be helpful to display it in the
network map. However, it does not force routes to go through the repeater.
10. Installation Best Practices
10.1 Avoiding Interference
In-band interference within “view” of either radio in a link can significantly
degrade communications. Attempt to avoid locating radios and antennas near
other transmitters or transmitting through commercial communication tower
locations. Additionally, a powerful signal of almost any frequency at very close
range can simply overwhelm a receiver. Test such a site with a representative
setup before committing to it. Relocating an antenna by a few feet vertically or
horizontally or constraining the radiation pattern with a directional antenna
may make a significant difference. Keep in mind that commercial tower sites