User Manual
13
Figure 6-3. FTP USR directory
In order to use FTP, the datalogger FTP User Name and FTP Password must be
set. This is done using
DevConfig
.
6.3.1.1
Step 1
– Configure Datalogger
a.
Connect serial cable from PC COM port to datalogger
RS-232
port.
b.
Open Campbell Scientific’s
DevConfig
. Select the
Device Type
of the
datalogger (CR1000 or CR3000), the appropriate
Communication Port
, and
Baud Rate
.
Connect
to the datalogger.
c.
Under the
Net Services
tab, verify that
FTP Enabled
is checked. Input the
FTP User Name
and
FTP Password
.
d.
Press the
Apply
button to save the changes and then close
DevConfig
.
Using
anonymous
as the user name with no password allows FTP
access without inputting a user name or password.
6.3.1.2
Step 2
– Access File System
a. Datalogger must be set up for Ethernet communications as explained in
Sections
4.1
,
Physical Setup
(p. 2)
, and
4.2
,
Communicating via Ethernet
(p. 2)
(Step 1 only).
b.
Open a Windows Explorer window. Enter
ftp://username:[email protected]
where nnn.nnn.nnn.nnn is the
IP address of the datalogger.
NOTE
