NL121 Ethernet Module
2
4.
Quickstart
This section describes the basics of communicating via Ethernet with the NL121
.
4.1
Physical Setup
Always collect your data before attaching the NL121.
Always power down the datalogger before installing or
removing the NL121 to or from the datalogger.
After powering down the datalogger, plug the NL121 into the datalogger
peripheral port (see Figure
4-1
). Attach Ethernet cable to the Ethernet port.
Restore power to the datalogger.
Figure 4-1. NL121 attached to a CR1000
4.2
Communicating via Ethernet
4.2.1
Step 1
– Configure Datalogger
a.
Connect serial cable from PC COM port to datalogger
RS-232
port.
b.
Open Campbell Scientific’s
Device Configuration Utility
(
DevConfig
). Select
the device type of the datalogger (CR1000 or CR3000), the appropriate
Communication Port
, and
Baud Rate
.
Connect
to the datalogger.
CAUTION
CAUTION
