CS725 Snow Water Equivalent Sensor
20
•
If it is not in Auto mode, verify that it was set to HCalib mode. A common
error is to leave it in Manual mode.
Reset to HCalib mode and let the sensor establish baseline at
midnight. Re-check the sensor operation the next morning after 6 am.
•
If in Auto mode, execute the [.fl] command.
Ex: ?<Enter>
.fl<Enter>
Sample output generated after 6:00am:
2
3
4
5
6
7
8
9
10
11 12 13 14 15 16 17 18 19
20
4/2014 11:59: SWESITE1 1065 57037 13168 6074 371 309 392 18 18 77 1
7
19 24 13 4.2 12.23
2
3
4
5
6
7
8
9
10
11 12 13 14 15 16 17 18
19
20
4/2014 17:59: SWESITE1 1065 69645 13016 6415 371 360 375 18 18 27 1
2
8
24 12
3.2
12.23
The format is the date and time stamp followed by the following numbers:
1.
Date
2.
Time Stamp
3.
Station ID (up to 8 alphanumeric characters)
4.
CS725 Serial number
5.
K counts total (uncorrected)
6.
K counts total (corrected) - this value is used in the SWE calculations
7.
Tl counts total (corrected) -this value is used in the SWE calculations
8.
SWE value generated from
40
K
9.
Ratio generated from K and Tl
10.
SWE value generated from Tl
11.
Soil Moisture values generated from K
12.
Soil Moisture values generated from Tl
13.
Soil Moisture values generated from K and Tl
14.
Precipitation index: Flag indication recent snowfall or rain
15.
Crystal temperature min
16.
Crystal temperature max
17.
Total number of histogram blocks used for the analysis
18.
Displacement of the K peak from its nominal position (in bins)
19.
Statistical significance of the SWE Tl measurement
20.
Power input voltage at the CS725 (after protection diode drop)
Verify that there are K counts total (column 4) and that there are about 6 times the counts you
measured the day before when evaluating the site, as the ouput is over a 6 h period instead of a
1 h period.
Verify that there are Tl counts total (column 6) and that there are about 6 times the counts you
measured the day before when evaluating the site, as the ouput is over a 6 h period instead of a
1 h period.
SWE at (7) should be ‘0’
SWE at (9) should be ‘0’
Summary of Contents for CS725
