Campbell CS705, Product Manual

Page: 15 / 27

Attach the mounting bracket/tipping bucket assembly to the mounting pipe or mast:
1.
Install and level the mounting pipe or mast.
2.
Loosen the mounting bracket’s wingnuts and slide the assembly over the pipe. If necessary,
the pole mounting hardware can be removed to get the bolts around the pipe. If this is
necessary, to reassemble, put the mast clamp on first followed by the flat washer, lock
washer, and wingnut. See FIGURE 6-7 (p. 10).
3.
Tighten the assembly onto the pipe, while ensuring that nothing is blocking the top of the
rain ga
u
ge.
4.
Adjust the two bolts on the leve
l
ling springs until the bubble in the level is inside the
bullseye.
FIGURE 6-7. Exploded view of CM270 mounting hardware (TE525WS not shown)
6.4 CS705-to-tipping bucket installation
procedure
Equipment required:
l
User-supplied 0.5-inch (inner diameter) vinyl or Tygon tubing
l
Pail
l
TE525WS Texas Electronics Rain Ga
u
ge
l
CS705 Snowfall Adapter
l
PGE antifreeze
l
Small band clamp
CS705 Snowfall Adapter 10