Campbell CS451, Product Manual

Page: 25 / 52

CS451/CS456 Submersible Pressure Transducer
13
programming code to start a new program or add to an existing custom
program.
Short Cut cannot edit programs after they are imported and edited
in CRBasic Editor .
A Short Cut tutorial is available in Section 4 , QuickStart
(p. 2)
. To import Short
Cut code into CRBasic Editor to create or add to a customized program, follow
the procedure in Appendix A ,
Importing Short Cut Code into CRBasic Editor
(p. A-1)
. Programming basics for CRBasic data loggers are provided in the
following sections. Complete program examples for select CRBasic data
loggers can be found in Appendix B , Example Programs
(p. B-1)
. Programming
basics and programming examples for Edlog data loggers are provided at
www.campbellsci.com\old-manuals .
The SDI12Recorder() measurement instruction programs CRBasic data
loggers to measure the CS451/CS456 sensor.
For most CRBasic data loggers, the SDI12Recorder() instruction has the
following syntax:
SDI12Recorder (Destination, SDIPort, SDIAddress, “SDICommand”,
Multiplier, Offset, FillNAN, WaitonTimeout)
For some of the SDI-12 commands, the Destination parameter must be an
array. The required number of values in the array depends on the command
(TABLE 8-3 ).
FillNAN and WaitonTimeout are optional parameters (refer to CRBasic Help
for more information).
Section 8.2 , SDI-12 Commands
(p. 17)
, lists the SDI-12 commands, the returned
data, and other information about the SDI-12 instruction.
7.5 Changing Nose Cones
The procedure to change or replace a nose cone follows:
1. Remove the two screws (FIGURE 7-4 ).
2. Pull the nose cone away from the sensor housing.
3. Insert the new nose cone into the sensor housing.
4. Replace and tighten the screws.
NOTE