Campbell cs215, Instruction Manual

Page: 33 / 44

Appendix B. Example Programs
B.2 Edlog Program
The following example is written for the CR10(X). Programs for the CR500,
CR510, and CR23X would be similar. The program below shows a simple
example reading a sensor which has been set up with address 0 (the default)
and connected to control port 1.
;{CR10X}
;Example program for a CS215 sensor on control port 1
;Measures every minute and stores some summary statistics
;once per hour
*Table 1 Program
01: 60
Execution Interval (seconds)
;Measure the sensor on control port 1
;Note you have to manually assign the labels in the Inloc Editor
;to make sure two locations are free.
1: SDI-12 Recorder (P105)
1: 0000
SDI-12 Address
2: 00 SDI-12 Command
3: 1 Port
4: 1 Loc [ Temp ]
5: 1. 0 Mult
6: 0.0 Offset
;Now store some statistics.
2: If time is (P92)
1: 0
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 10 Set Output Flag High (Flag 0)
3: Real Time (P77)
1: 111
Day,Hour/Minute,Seconds (midnight = 0000)
4: Average (P71)
1: 1
Reps
2: 1 Loc [ Temp ]
5: Sample (P70)
1: 1
Reps
2: 2 Loc [ RH ]
*Table 2 Program
02: 0.0000 Execution Interval (seconds)
*Table 3 Subroutines
End Program
B-3