Campbell CELL200 Series, Product Manual

Page: 35 / 102

6.3.1 Module communications connections 25
6.3.2 Module power connections 28
6.3.3 Antenna connections 29
6.4 CELL200 series and data logger configuration 30
6.4.1 Integrated mode option 30
6.4.2 Non-integrated mode option 30
6.4.3 Serial server mode option 36
6.4.4 Serial client mode option 43
6.4.5 Serial server/client mode option 49
6.1 Base station requirements
A computer running Campbell Scientific LoggerNet software with access to the Internet is
needed.
6.2 Data logger site equipment
l
CELL200-series module with power cable (included with module)
l
Data logger — CR1000X series, CR300 series, CR6 series, CR1000, CR3000, CR800 series,
CR5000, and GRANITE 6/9/10
l
Module Interface, see Module communications connections (p. 25)
l
Environmental Enclosure — ENC10/12, ENC12/14, or ENC16/18
If connecting to CS I/O port:
SC12 cable (preferred for CR1000X series, CR300 series, CR6 series, CR1000, CR3000,
CR800 series, CR5000, and GRANITE 6/9/10 data loggers ) — connects the module to
current data logger with a CS I/O port. See
CS I/O connection (p. 27)
SC105 Interface — connects the module to any data logger with a CS I/O port. It must
be configured using Device Configuration Utility. Settings should be:
l
CS I/O Mode: Modem Enable
l
CS I/O ME Baud Rate: 9600
l
RS-232 Mode: Modem (default)
l
Baud Rate:
l
115.2K for CR1000X series, CR300 series, CR6 series, CR1000, CR3000, CR800
series, CR5000, and GRANITE 6/9/10 data loggers
CELL200-Series 4G LTE Cellular Module 23