35
PW1750
Notes
Notas
SAVE THESE INSTRUCTIONS
When using this product, basic
precautions should always be followed,
including the following:
1.
Read all instructions before using the
product.
2.
ALWAYS disconnect power before
disassembling or repairing the unit.
3.
Follow all safety codes as well as the
Occupational Safety and Health Act
(OSHA).
4.
Ensure safety devices are operating
properly before each use. DO NOT
remove or modify any part of the gun
or unit.
5.
Know how to stop this product and
bleed pressure quickly. Be thoroughly
familiar with the controls.
6.
Stay alert – watch what you are doing.
7.
Do not operate the product when
fatigued or under the influence of
alcohol or drugs.
8.
Keep operation area clear of all
persons.
9.
Do not overreach or stand on
unstable support. Keep good footing
and balance at all times.
10. Follow the maintenance instructions
specified in the manual.
11. This product is provided with a ground
fault circuit interrupter, GFCI, be sure
to inspect cord and GFCI prior to use.
Any repair or replacement of the
power cord must be performed by a
qualified (licensed or certified)
electrical technician.
12. Never use an extension cord with this
product.
2
www.chpower.com
Operating Instructions and Parts List
PW1750
Important Safety Instructions
! IMPORTANT !
This pressure washer is equipped with a
microswitch sensitive to water flow. This
Instant Start/Stop switch (ISS) senses
water flow in the pump. When the trig-
ger is released, water stops flowing
through the pump. The ISS then auto-
matically turns the motor off to protect
pump from overheating.
OPERATION
1. Pull trigger on gun.
2. Turn the “ON/OFF” switch to “ON”.
3. Release trigger. The pressure washer
motor will stop running.
4. To spray again, pull trigger and motor
and pump will restart.
Note
: Occasionally the motor may run
for a short time to bring fresh, cool
water into the pump even if trigger is
released. This is part of normal opera-
tion and will not damage the unit.
Always turn the
“ON/OFF” switch
to “OFF” then trigger gun to release
hose pressure before unplugging
power cord.
Risk of equipment
damage. Always
make sure the “ON/OFF” switch on the
unit is “OFF” and unit is unplugged
prior to storage.
Risk of Injection.
Unit will start
spraying when trigger is squeezed if
ON/OFF switch is in “ON” position.
Always point gun in safe direction.
Call 1-800-330-0712
for Technical Service
