Campbell Hausfeld DC0100, Operating Instructions And Parts List Manual

Page: 2 / 12

Operating Instructions and Parts List
2
www.campbellhausfeld.com
DC0100, FP2098 Series
General Safety Information
CALIFORNIA PROPOSITION 65
This product or its
power cord may
contain chemicals, including lead,
known to the State of California to
cause cancer and birth defects or other
reproductive harm. Wash hands after
handling.
You can
create
dust when you cut, sand,
drill or grind materials
such as wood, paint, metal,
concrete, cement, or other masonry.
This dust often contains chemicals
known to cause cancer, birth defects,
or other reproductive harm. Wear
protective gear.
GENERAL SAFETY
Since the air compressor and other
components (material pump, spray
guns, filters, lubricators, hoses,
etc.) used, make up a high pressure
pumping system, the following safety
precautions must be observed at all
times:
1. Read all manuals
included with this
product carefully. Be
thoroughly familiar with
the controls and the proper use of
the equipment.
2. Follow all local electrical and safety
codes as well as in the United
States, the National Electrical Codes
(NEC) and Occupational Safety and
Health Act (OSHA).
3. Only persons well acquainted
with these rules of safe operation
should be allowed to use the
compressor.
4. Keep visitors away and NEVER
allow children in the work area.
5. Wear safety glasses and
use hearing protection
when operating the
unit.
6. Do not stand on or use the unit as
a handhold.
7. Before each use, inspect
compressed air system and
electrical components for signs of
damage, deterioration, weakness
or leakage. Repair or replace
defective items before using.
8. Check all fasteners at frequent
intervals for proper tightness.
Motors,
electrical
equipment and controls can
cause electrical arcs that
will ignite a fl ammable gas
or vapor. Never operate or repair in or
near a fl ammable gas or vapor. Never
store fl ammable liquids or gases in the
vicinity of the compressor.
Compressor parts may
be hot even if the unit is
stopped.
9. Keep fingers away from a
running compressor; fast moving
and hot parts will cause injury and/
or burns.
10. If the equipment should start
to vibrate abnormally, STOP
the engine/motor and check
immediately for the cause.
Vibration is generally a warning of
trouble.
11. To reduce fire hazard, keep engine/
motor exterior free of oil, solvent,
or excessive grease.
An ASME code
safety relief valve
with a setting no higher than 125 psi
MUST be installed in the tank for this
compressor. The ASME safety valve
must have suffi cient fl ow and pressure
ratings to protect the pressurized
components from bursting.
See compressor
specifi cation decal
for maximum operating pressure.
Do not operate with pressure switch
or pilot valves set higher than the
maximum operating pressure.
12. Never attempt to adjust ASME
safety valve. Keep safety valve
free from paint and other
accumulations.
Never use plastic
(PVC) pipe for
compressed air. Serious injury or death
could result.
Never
attempt
to repair or modify a tank!
Welding, drilling or any
other modifi cation will
weaken the tank resulting in damage
from rupture or explosion. Always
replace worn, cracked or damaged
tanks.
Drain liquid from
tank daily.
13. Tanks rust from moisture build-up,
which weakens the tank. Make
sure to drain tank regularly and
inspect periodically for unsafe
conditions such as rust formation
and corrosion.
14. Fast moving air will stir up dust
and debris which may be harmful.
Release air slowly when draining
moisture or depressurizing the
compressor system.
15. Indoor use only.
16. To reduce the risk of electrical
shock, do not expose to rain. Store
indoors.
SPRAYING PRECAUTIONS
Do not
spray
fl ammable materials in
vicinity of open fl ame
or near ignition sources
including the compressor unit.
17. Do not smoke when spraying paint,
insecticides, or other flammable
substances.
18. Use a face mask /
respirator when spraying
and spray in a well
ventilated area to
prevent health and fire hazards.
19. Do not direct paint or other
sprayed material at the compressor.
Locate compressor as far away
from the spraying area as
possible to minimize overspray
accumulation on the compressor.
20. When spraying or cleaning with
solvents or toxic chemicals, follow
the instructions provided by the
chemical manufacturer.
MANUAL
Serie DC0100, FP2098
23 Sp
Manual de Instrucciones de Operación y Lista de Piezas
Para ordenar repuestos, sírvase llamar al distribuidor
más cercano a su domicilio
Sírvase darnos la siguiente información:
- Número del modelo
- Número de serie (de haberlo)
- Descripción y número del repuesto según la lista de repuestos
Puede escribirnos a:
Campbell Hausfeld
Attn: Customer Service
100 Production Drive
Harrison, OH 45030
13
1
2
23
24
21
20
30
29
22
35
32
19
10
34
9
26
18
31
14
25
11
28
7
8
16
17 18
27
6
5
4
3
33
12
Lista de Repuestos
No. de
Ref. Descripción
Número del
Repuesto
Ctd.
1 Tapa FP209536AV 1
2 Interruptor de encendido/
apagado
FP204824AV 1
3 Tornillo ▲ 4
4 Cubierta del múltiple ▲ 1
5 Regulador ▲ 1
6 Manómetro del regulador FP209528AV 1
7 Manómetro del tanque FP209821AV 1
8 Válvula de seguridad V-215104AV 1
9 Aislador del motor ■ 2
10 Interruptor de presión FP209538AV 1
11 Valvula de chequeo FP209532AV 1
12 Cord No disponible No
disponible ón eléctrico FP209534AV 1
13 Tornillo de la cubierta ◆ 4
14 Tuerca ◆ 4
15 Válvula de drenaje D-1403 1
16 Patas de caucho
●
4
17 Perno de pata
●
4
18 Cable (interruptor de presión a
interruptor de corriente)
FP209523AV 1
19 Ensamblaje de bomba/motor DC010001AV 1
20 Sujetador del cable FP202823AV 1
21 Tornillo
❋
1
22 Cubierta del motor
▼
1
23 Accesorios (solo modelo FP2098) FP204008AV 1
24 Manguera de retroceso de
7,62 m (solo modelo FP2098)
MP268100AV 1
25 Base plástica
▼
1
26 Juego de tubo del Presostato FP209535AV 1
27 Tanque — 1
28 Tapa plástica — 4
29 Tornillo autorroscante con
arandela
◆ 2
30 Tornillo de la cubierta del motor ◆ 4
31 Tornillo de base ◆ 4
32 Soporte del interruptor de
presión
— 1
33 Tornillo de descarga a tierra ❋ 1
34 Relevo de tensión — 1
35 Tubo de escape FP202839AV 1
JUEGOS DE REPUSTOS Y ACCESORIOS
▲ Ensamblaje del distribuidor FP209820AV
■ Kit de aislador (Incluye #4) FP209037AV
●
Kit de pés FP209522AV
◆
Juego de sujetadores FP209041AV
▼
Juego de la cubierta del motor FP209038AV
❋
Artículo estándar de ferretería
— No disponible