6
Operating Instructions
www.campbellhausfeld.com
Operating the Tool
(Continued)
3. Undo latch by
pulling out
and down. The
wire latch will
disengage from
the hooks on the nose.
4. The door can
now be rotated,
exposing
the jammed
fastener.
5. Remove the
jammed
fastener, using
pliers or a
screwdriver if
required.
6 Rotate
door
back into the
closed position.
7. Extend the wire
latch and place
over the hooks
on the nose.
8. Close the latch
by pushing the
latch up and
in until the
latch snaps into
place.
9. Make sure the
trigger and
work contact
element (WCE)
move freely
up and down
without sticking or binding.
2. For shallow
penetration,
turn the
wheel (C)
to right to
the extent
desired.
3. For deeper
penetration,
turn the wheel (C) to left to the
extent desired.
4. Make sure trigger
and work contact
element (WCE) move
freely up and down
without binding or
sticking after each
adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is
equipped with
an adjustable
direction exhaust
deflector. This is
intended to allow
the user to change the direction of the
exhaust. Simply twist the deflector to
any direction desired.
CLEARING A JAM FROM THE TOOL
1. Disconnect the
air supply from
the nailer.
2. Remove all
fasteners from
the magazine
(see “Loading/
Unloading The
Nailer”).
Failure to remove
all fasteners will
cause the fasteners to eject from the
front of the tool.
LOADING/UNLOADING THE TOOL
1. Always
disconnect
the tool from
the air supply
before
loading
fasteners.
2. Push down
on the latch
button. Pull
back on the
magazine cover.
3a. For nails, insert
a stick into
the magazine.
Make sure the
pointed ends
of the fasteners are resting on the
bottom ledge of the magazine when
loading. Make sure the nails are not
dirty or damaged.
3b. For staples, load
a clip of staples
with the crowns
straddling the
magazine rail.
4. Push the
magazine cover
forward until
latch button
pops up.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except that you must
disconnect
the air supply before unloading.
ADJUSTING THE FASTENER
PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so
fasteners are driven consistently. Do
not exceed 100 PSI.
(C)
Rotate
Magazine
rail
Latch
button
Movement
