FT-305 Wiltshire Fountain
Assembly Instructions
Three people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1,001 lbs with an
approximate 2.75 sq. ft. footprint (actual dimensions 20" x 20").
Step 1 - Place the base (FT-114I) into position where the fountain will be installed, ensuring that it
is level.
1a - Note: Check that all components are leveled as the fountain is assembled.
FT-114I (140 lbs)
20"L x 20"W x 6"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 2 - Center the large pedestal (FT-114H) over the base.
Step 3 - Assemble the fountain plumbing:
3a - Attach the 3/4" clear tubing end of the tubing assembly to the pump outlet.
3b - Place the stopper around the pump cord approximately 6" from the pump.
Step 4 - Center the large bowl (FT-114G) over the large pedestal (FT-114H) making sure the holes
line up.
Step 5 - Feed the pump cord all the way through the holes in the bowl (FT-114F) and pedestal
(FT-114H) then out of the access door in the base (FT-114I).
Step 6 - FIRMLY press the stopper into the hole evenly.
6a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 7 - Insert the #7 Drain Stopper into the small drain hole.
FT-114H (150 lbs)
15.5"L x 15.5"W x 18"H
FT-114G (327 lbs)
47"W x 6.5"H
