FT-225 Longvue Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 630 lbs with an
approximate 1.75 sq. ft. footprint (actual dimensions 16.25" x 16.25").
Step 1 -
Place the base (FT-225F) into position where the fountain will be installed, ensuring that it
is level.
FT-225F (224 lbs)
16.25"L x 16.25"W x 24.5"H
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
Step 2 -
Assemble the pump kit:
2a -
Using a hose clamp, attach the non-kink tubing to the pump outlet.
2b -
Place the stopper around the pump cord about 6” from the pump.
Step 3 -
Center the large bowl (FT-239E) over the base (FT-225F).
Step 4 -
Feed the pump cord through the hole in the large bowl (FT-239E) and the channel in the
base (FT-225F).
Step 5 -
FIRMLY press the stopper into the hole evenly.
5a -
Note: Using the handle of a screwdriver or hammer works best.
Step 6 -
Place the pump house (FT-225C) over the pump and in the center of the large bowl
(FT-239E).
Step 7 -
Feed the non-kink tubing through the top of the pump house (FT-225C).
FT-239E (210 lbs)
36.5"W x 10"H
FT-225C (39 lbs)
10"W x 13"H
