FT-380 Mondrian Fountain, Tall
Assembly Instructions
Step 12 - Place pump cover (FT-379C) around the pump and the cord. Be sure that it is centered
under the three spouts in the water feature (FT-380B).
Step 13 – Carefully place the copper mesh (FT-379CP) into the recess at the top of the pump
cover (FT-379C).
Step 14 – Place the spiller stop (FT-380A) on top of the water feature (FT-380B). The square parts
in the bottom of the spiller stop should sit into the square holes at the top of the water
feature.
Step 15 – Installing the spillers
15a – Insert a blue Matala filter square into each spiller (FT-380SPL). See figure A (back
view).
Step 16 – Use the silicone provided to secure the spillers into the spillways on the water feature
(FT-380B).
Note – For best results when installing spillers, apply two heavy, constant beads of
silicone spaced slightly apart on the bottom / outside of the side walls. Press the
spiller securely into the fountain’s spillway and gently wipe away any excess
silicone with a damp (not wet) cloth or towel.
Note – More silicone can be used after the spillers are secure and dry to fill any gaps
between the spillers and the water feature.
Step 17 - Let the fountain sit 24 hours before filling with water to let the silicone dry completely.
TROUBLESHOOTING NOTE: If water is seen running down the wall of the water feature, let the
fountain dry completely and check for gaps between the spillers and the water feature. Also, a
thick bead of silicone can be used to fill the gap where the water feature and basin meet.
FT-379C (22 lbs)
11.5"L x 6.5"W x 7"H
FT-380A (12 lbs)
21"L x 3.75"W x 3"H
Fig. A
