FT-118 Moderne Fountain
Two people are recommended for the installation of this fountain!
Revised March 31, 2017
Assemble your fountain on a level surface capable of holding a minimum of 832 pounds with an approximate 3 square foot footprint.
FT-118B (632 lbs)
FT-118D (18 lbs)
Copper Spiller
FT-118E (2 lbs)
FT-118A (121 lbs)
1.
Assemble the pump kit and stopper
a.
Using a hose clamp, attach the end of the 1/2" non-kink tubing without the clear tubing to the
pump outlet.
b.
Spread a small amount of silicone
THINLY
around the LED light cord approx. 24” from the
light.
c.
Do the same around the pump cord about 12” from the pump.
d.
Press the two cords together.
e.
Place the #10 stopper around both cords.
2.
Feed both cords through the large hole in the fountain basin (FT-118B) and through the channel, which
is located in the back right corner of the base.
3.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the stopper in place.
4.
Connect the 5/8” clear vinyl tubing to the PVC pipe in the bottom of the basin (FT-118B).
5.
Spread a thin bead of putty around the perimeter of the stopper.
6.
Place the fountain disc (FT-118D) into the basin.
7.
Pull the LED Light through the hole in the fountain disc (FT-118D) so it can rest on top.
a.
Be careful not to pull the stopper loose.
8.
Use the silicone provided to install the copper spiller. (Image below)
a.
Be sure the spiller is clean and dry before installing
9.
Insert the spiller stop (FT-118E) into the slot behind the copper spiller.
a.
Be sure that the 2 PVC pipes protruding upward are covered by the spiller stop (FT-118E).
10.
Run a thin bead of silicone around the top of the basin (FT-118B) where the fountain top (FT-118A)
will be placed.
11.
Carefully place the fountain top (FT-118A) onto the basin (FT-118B).
a.
Be sure to clean away any excess silicone.
12.
Connect the LED Light to the LED Transformer.
13.
Let the fountain sit 24 hours before filling it with water.
