144527-XX01 Eero Angkor Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 95 lbs with an approximate 1.5 sq. ft.
footprint (actual dimensions 10.5" Diam.).
Step 1 -
Assemble the pump kit:
1a -
Using a hose clamp, secure the 1/2" end of the tubing assembly to the pump.
Step 2 -
Remove the cap covering the standpipe.
Step 3 -
Feed the pump cord through the standpipe until the cord exits the bottom of the basin and can be plugged in.
3a - Note: Leave enough cord length inside of the basin to work with the pump sitting flat on its side in the
bottom of the bowl.
Step 4 -
Replace with the cap from the pump kit to cover the standpipe and cord.
Step 5 -
Slide the 5/8" end of the tubing assembly onto the copper pipe extending down from the bottom of the water feature.
Step 6 -
Place the water feature on top of the basin making sure that the water feature is level.
6a - Note: Wedges may be used if necessary to level the water feature.
6b - Note: Do not fill water over the top of the standpipe.
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
