34
Alcan Cover
The Alcan cover (front padded bra) is good for preventing stone damage
to the front of the trailer or may be added later to cover damage. Once
installed, it is usually left in place. The cover will trap moisture and
cause the aluminum beneath it to tarnish. The tarnish will actually slow
the rate of corrosion.
If you travel in areas with road salt or ocean spray, you will want to
wash under the Alcan cover as soon as possible to minimize corrosion.
To clean under the Alcan Cover:
Unhook the elastic under the trailer.
Lift up the flaps to wash underneath.
Dry or allow to air dry fully before re-hooking elastics.
The Alcan cover may be removed by sliding the top sideways
out of the rail at the top.
(it does not need to be removed for
normal cleaning)
Under the Alcan Cover is an ideal place to test any aluminum
cleaners. After testing, rinse area and let completely dry before
using on other areas of the trailer.
Receiver Hitch Option
If your
Camp-Inn
™ is equipped with a receiver hitch, you can use it to
haul bicycles. The receiver hitch has a
150 lb. load limit
(bikes and bike
carrier weight combined). It is designed and intended only for a two bike
carrier. It has not been designed or tested for towing a second trailer or
using any other receiver type cargo carrier. Exceeding the load limit of
the receiver hitch will reduce tongue weight, and may create a hazardous
towing situation.
Windscreens Option
The windscreens in the kitchen snap into place. They may be rolled up or
fully removed when not needed.
Roll the windscreens inward so they do not interfere with closing the
hatch. When using the Velcro tie-backs, bias them toward the inside of
the trailer. If they are biased to the outside, they may interfere with the
hatch seal.
