10
Instructions for lighting burner:
Do not lean over LP cooker while lighting.
Read all instructions before lighting and only
light burner outdoors.
1. Remove all appliances and pots from the
burner to create a free flow of air.
2. Turn control valve(s) to OFF position.
3. Ensure there is a minimum of 24 inches
(61 cm) between the LP tank and the
appliance.
4. Turn the timer knob clockwise until it
stops.
5. Slowly open LP bottle valve.
6. Hold down the safety button on the top
of the igniter box and hold the ignition
button while rotating the regulator control
knob until burner is lit.
7. If ignition does not occur in 5 seconds,
turn the burner control(s) off, wait
5 minutes, and repeat the lighting
procedure.
8. Continue to hold down the safety button
for 10 seconds while the thermocouple is
heated.
9. Turn the regulator control knob to the
desired heat output position between ON
and OFF.
SAFETY BUTTON
TIMER KNOB
IGNITER BUTTON
REGULATOR CONTROL KNOB
The timer included on the front of this
appliance is a safety feature to prevent an
uncontrolled fire. This timer will automatically
shut off gas to the burner after 15 minutes.
To cook for a longer period, reset your timer
by turning clockwise every few minutes.
NOTE: it takes approximately 3.5 minutes
per pound of turkey. So a 18 lb (8.1 kg)
turkey will take around 63 minutes. You will
need to reset the timer throughout the cook.
Remember to watch the temperature of the
oil to ensure your oil doesn’t overheat.
Instructions for lighting burner with match:
Do not lean over LP cooker while lighting.
Read all instructions before lighting and only
light burner outdoors.
1. Remove all appliances from the burner to
create a free flow of air.
2. Turn control valve(s) to OFF position.
3. Slowly open LP bottle valve.
4. Light a long match (fireplace match) and
place it over burner. If using a short match,
place the unlit match into the match holder
then light the match. Slowly rotate the the
regulator control knob until burner is lit.
5. If ignition does not occur in 5 seconds,
turn the burner control(s) off, wait
5 minutes, and repeat the lighting
procedure.
