www.imc-multimedia.com
17
9.5 USALS
This convenient function locates the desired satellite by USALS if latitude/longitude of the receiving
place and satellite longitude are known.
Move to USALS mode by using the buttons at the DiSEqC item in the "General Settings"
menu.
Move to "Auto Search" or "Manual Search" to search the desired channel in USALS mode.
Click the DiSEqC item in the Auto Search Menu to open the USALS Setting Popup Menu.
Enter the user location latitude and longitude. Use numeric keys to enter values. Use
buttons to convert East and West.
Enter the latitude and longitude of the desired satellite. Use numeric keys to enter values.
Use buttons to convert East and West.
Click Store to save the input information. The antenna will direct itself towards the computed
USALS result.
If it is physically impossible to direct the satellite, an error will be displayed. Press the "Back" key
and enter new information if this happens.
Use the Signal Strength Bar to check if a satellite signal is received from the new antenna direction.
Use Nudge East/West or Go to Reference to help the antenna work.
9.6 Auto Search Function
Auto Search is the one used most frequently used methods of channel search. It is intended to
have the receiver automatically search all the channels from the satellite you selected.
Select "Auto Search" and then press the OK button.
Select the satellite using the OK button. If you want to
change the Satellite Information, press the button on the
remote control.
Set the LNB information and DiSEqC information for the
satellite. You can use the existing setting. To change the
setting, use the buttons.
Set DiSEqC port to OFF (or to a port you want to use, if any)
Start searching for TV and radio channels using the above
settings. Press the OK button.
TV and radio broadcast channels will be searched.
The names of the channels will be listed.
Press the EXIT button to return to viewing mode and check
whether the reception of the selected channel is good.
Note on Network Search:
In this search mode, the receiver first collects the network information first from the TP you
selected. Then an Auto Search takes place to research all the channels in that network. The
number of searched channels may vary, depending on the TPs present in that network. Select
whether to use the network information of the TP stream specified in "Select Transponder". I.e,
download the TP information of the satellite you want to find from a particular TP and then use this
to Auto Search the channels in the TP group. The number of channels searched may vary
depending on the TP information transmitted. Select Network Search and then use the
buttons to set it.
Summary of Contents for CSA-130P
Page 25: ...12 CM 1510 TM 1510 1 2 3 4 5 6 7 8...
Page 29: ......
