7
INSTALLATION
4
Please read the following points prior to installation.
- Turn off the product before installation, and ensure the vehicle key is not inserted and turned on at
any time during the installation.
- Only use the cables supplied. Do not use any other unverified cable.
- Any vehicle with dark or metallic tinting may have a negative influence on the GPS signal strength.
- Be sure to eliminate potential wave interferences around the GPS antenna and completely separate
from other devices and cabling, such as a hi-pass filter, navigation equipment etc.
GPS antenna connection
Connect the DVR to a GPS antenna to collect data including driving route, speed, time, direction
and location information.
* Recommended GPS antenna installation position
* Receiving a GPS signal could be impaired by tinting or a coating material on the window. It is not a product fault,
but a situation caused by metallic tinting or a metal component in the glass such as heat/demister wires. In this
case, relocate the antenna to a place where there are no obstructions.
* Before attaching the GPS antenna, clean the surface and then secure firmly with double-sided tape, making sure the
“GPS” engraved side is facing upward. The attached double-sided tape will reach maximum strength after 24 hours.
Install with the “GPS” engraved
side facing upward.
Tin
ting
se
ction
G
PS a
nt
en
na
Ensure GPS antenna does not overlap
the tinted section of the window.
