11
Firmware update
Error Check
Please carefully read the below information if using an SD card over 64GB.
- The CAMOS DVR supports automatic formatting (FAT32) when a memory card larger than
64GB is first used.
- Only format memory cards using the PC Viewer Manager software.
- Proceed with the firmware update only after formatting the SD card via the PC Viewer
Manager. (The firmware update might not proceed after formatting on a PC, depending on
the file system selected (e.g. exfat). In this case, reformat using the PC Viewer Manager only,
which will use the correct format (FAT32). The firmware update will now proceed as normal.)
Firmware update
1. The previous version of firmware will be updated automatically if a
new update file is found during initial booting.
2. All LEDs flash every two seconds until the firmware update finishes.
* Please make sure the power stays on while updating.
Error Check
1. All LEDs flash every second when an error occurs or the SD card is
removed with power being connected. There will be a continuous
audible beep until the SD card is re-inserted or the power is turned off.
* The device turns on/off when the cover is opened and closed. Please
insert or remove the SD card by opening and closing the cover with the
engine off in order to prevent damage to recorded data stored on the
SD card.
Finished Recording
1. All LEDs turn off and then turn back on at the end of a normal,
successful recording.
