CAMON C500 Stump Grinder
CAMON C500 Stump Grinder
CAMON-C500/11.11/6
WARNING
!
Transporting the Machine
The C500 is designed to be transported via a van or small trailer. The machine is equipped with grab bars that
are to be used for both lifting the machine, and strapping it down. This machine weighs approximately 118kg
and should only be lifted by a minimum of two people in proper physical health. Know your limits.
There are legal road requirements for towing equipment and trailers (such as lighting and licensing). It is the
owner/operator’s responsibility to be aware of these laws and to adhere to them.
Pre-Starting Inspection
NOTICE
To ensure the long life and economical operation of your C500, we highly recommend that the
owner/operator be well instructed in both the operation and maintenance of this machine.
Inspect the machine and perform each of the “10 Service Hours or Daily” (see MAINTENANCE section)
maintenance inspections and services as found necessary before operating the machine.
Starting the Engine
Read and understand the SAFETY section of this manual, in its entirety, before proceeding.
Do not start the engine until the machine is in the cutting position, next to the stump!
1. Lock travel wheel by pulling brake lever fully back.
2. Make sure engine switch is “ON”.
3. Make sure throttle is in “SLOW” position.
4. If engine is cold, move the choke lever to the closed position.
5. Depress the operator presence lever.
6. Raise the cutter wheel off the ground 4” to 5” by pushing downward on the control handle. Hold it in
that position.
WARNING: The next step may cause the cutter wheel to rotate. Keep everyone away!
7. Pull the starter rope lightly until resistance is felt, then pull briskly.
8. Move the choke lever to the open position.
WARNING: The next step causes the cutter wheel to rotate. Keep everyone away!
9. Move the throttle to “FAST” position. If the engine is cold, allow the engine to idle (throttle set to
“SLOW” position) for a few minutes before cutting.
WARNING
!
OPERATION
OPERATION
WARNING
!
Removing Stumps
Before operating, please carefully review the SAFETY section for vital information relating
to the operation of this powerful machine!
NOTICE
Remove all loose pieces of wood, stones, wire and other
debris from the work area before beginning stump removal.
Wind direction should be considered, as it influences the
direction in which dust and wood chips will be directed.
Never operate the machine after dark. Night time
operation will not allow the operator to see the stump and
danger zone adequately enough for safe operation.
Always allow a cold engine time to warm up before cutting a
stump.
O
Only the portion of cutting wheel within the 80 area shown above should engage the stump.
Never undercut the stump or use the bottom of the cutting wheel for cutting purposes.
WARNING
!
CAMON-C500/11.11/7
