20/66
7 Performing measurements
As soon as the CAM mobile is switched on the device starts to measure and analyze the input quantities in
accordance with the configuration. Since the measurement is likely to take place over a longer time period, it is
important to check some basic settings, as otherwise the recorded measurement data can not produce the
desired result.
Data logger
The individual data loggers must be started during parameterization of the device. This is described in
the „
”. The state of the individual loggers can be requested only via CB-Manager
software using the USB interface.
Time and date
Check if time and date are correctly set in the device. See „
Min/Max values
If extreme values should be monitored, it makes sense to reset them after switching on the device, as
e.g. minimum values of voltage quantities will be set to 0.0V or the frequency will show the minimum of
the allowed frequency range (either 10 or 45Hz). This reset may be performed either by means of the
PC software or via display (see „
“). The same is valid for meter contents.
