Eye
RX
User
Guide
Page 153
RX-SE setting
4.
Select
[TEST]
option
and press “
Enter
”
button to test the connection of RX-SE. Result
will show in the STATUS. If it shows ERROR
or DISCONNECTED, you should check the
RX-SE connection and the IP address ,port
number or password correct or not. SERIAL
NO and VERSION represent the serial number
and version of RX-SE. It will show after the
RX-SE is connected.
Note:
There are several statuses.
STATUS :
MEANING :
DISCONNECTED
Disconnected
CONNECTED
Normal
INCORRECT PW
Incorrect password
SE BUSY
The RX-SE is in use
IP/PORT ERROR
Cannot establish connection
MOUNT ERROR
Testing result : HDD error
READ ERROR
Testing result : HDD error
WRITE ERROR
Testing result : HDD error
UMOUNT ERROR
Testing result : HDD error
VALID
Tested OK
5.
Select
[CONFIGURE]
option
and press
“
Enter
”
button.
6.
Select
[PASSWORD]
option
and press
“
Enter
”
button to change the password.
Note:
RX-SE IP can change here. The IP of RX-SE 1 will
change if you input a new IP.
RX-SE 1 SETTING
ENABLE
YES
IP
192.XXX.X.X
PORT
1025
PASSWORD ******
TEST
ENTER
STATUS CONNECTED
SERIAL NO XXXXX
VERSION XXXXX
CONFIGURE . . .
RX-SE 1 SETTING
ENABLE
YES
IP
192.XXX.X.X
PORT
1025
PASSWORD ******
TEST . . .
STATUS CONNECTED
SERIAL NO XXXXX
VERSION XXXXX
CONFIGURE
. . .
RX-SE 1 CONFIG
IP
192.XXX.X.X
PORT
1025
SUBNET 255.XXX.XXX.X
GATEWAY 192.XXX.X.X
PASSWORD
. . .
