IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
7
DMX
(“SAVE” is briefly displayed on the display). Connect the slave and the master unit (same model) with a DMX cable and activate one of the
standalone modes on the master unit. Now the slave unit follows the master unit.
SYSTEM SETTINGS
To adjust system settings, press the MODE button repeatedly until “dMX”, “PrEF”, “SLAV”, “Soun”, or “Auto” appears on the display. Use the
UP and DOWN buttons to select the “PrEF” menu item and confirm by pressing ENTER. You can now select and adjust one of the following
menu items using the UP and DOWN buttons (confirm with ENTER, exit with MODE):
UP/DOWN
-> ENTER ->
<- MODE
UP/DOWN
/
-> ENTER ->
<- MODE
YES = LED display
Is rotated by180°
(overhead mounting)
-> ENTER ->
<- MODE
UP/DOWN
/
YES = reversal of
PAN direction
-> ENTER ->
<- MODE
UP/DOWN
/
YES = reversal of
TILT direction
-> ENTER ->
<- MODE
UP/DOWN
/
on = display always on
off = display goes off after
approx. 20 seconds of inactivity
With this menu item, you can define
which operating mode should be enabled
when in the DMX mode,
the DMX signal is interrupted.
-> ENTER ->
<- MODE
UP/DOWN
(blackout)
(last command)
(Music control)
IR REMOTE CONTROL
In order to easily control the Moving Head via the supplied remote control, be sure to position the infrared
interface of the remote control in direct visual contact, at a maximum distance of 5 m from the infrared
interface of the spotlight and follow the sequence of operations (1. “STAND BY”, 2. “FULL ON”).
STAND BY
Press on “STAND BY”, to control the Moving Head in the IR remote control mode.
The LED display now shows “StoP” and the head moves in the upright position.
FULL ON
After the Moving Head has been brought into the IR remote control mode (see section “STAND BY”), press
“FULL ON” to switch on the LED illumination.
