5
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
2
3
1
4
7
5
6
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
1
POWER IN
IEC mains socket with integral fuse holder (5 x 20 mm fuse F3AL/250V). A suitable IEC power cable is included.
IMPORTANT NOTE:
Replace the fuse only with a fuse of the same type and value. Follow the instructions printed on the housing. In the
event of repeated fuse failure, please contact an authorised service centre.
2
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
3
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
4
HOUSING FAN
Ensure that the fan is not obstructed and that air can circulate freely.
5
LC DISPLAY
The illuminated LED display shows the active mode and other system information.
6
CONTROL BUTTONS
MENU – Press MENU to access the selection menu. Press repeatedly to go back to the main display.
ENTER – Press ENTER to access the menu levels to make value changes. Confirm value and status changes with ENTER.
UP and DOWN buttons – Press to move through the individual menu items in the selection menu and submenus (mode, system information,
etc.). Change a value, such as the DMX address.
7
MIC
Microphone for music-control mode.
OPERATION
PLEASE NOTE
When the lamp is correctly connected to the mains supply and the standby switch is on, the CAMEO logo is shown on the
display during start-up and motor reset. After this process, the spotlight is ready for operation and the previously selected mode will be activated.
