Cameo MOVOBEAM ZOOM 100, User Manual

Page: 9 / 68

IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
9
DMX
DMX Fail =
Operating status with DMX
signal fault
Hold = Last command is retained
or
black-
out,
= Activates blackout
Auto = Activates auto mode
Dimmer Curve = Dimmer curve
Linear = Light intensity increases linearly with DMX value
Exp
= Light intensity can be finely adjusted at lower DMX values and broadly
adjusted at higher DMX values
Log
= Light intensity can be broadly adjusted at lower DMX values and finely
adjusted at higher DMX values
S Curve = Light intensity can be finely adjusted at lower and higher DMX values
and broadly adjusted at medium DMX values
Pan Rev = Pan Reverse
Normal = No reversal of pan direction
Reverse = Reversal of pan direction
Tilt Rev = Tilt reverse
Normal = No reversal of tilt direction
Reverse = Reversal of tilt direction
Feedback = Position correction
ON = Automatic position correction activated
OFF = Automatic position correction deactivated
Fan Control = Fan speed
Regular = Maximum brightness with normal fan function
Silent = If necessary, reduced brightness with quiet fan
Mov Blackout =
Automatic blackout in the
event of head movement
ON = Blackout in the event of head movement
OFF = No blackout in the event of head movement
Calibrate
Correction of head position
for pan and tilt
Pan Position correction from -128 to +127
Tilt Position correction from -128 to +127
TEST = Function test
OFF = Stop function test
ON = Step-by-step function test of LEDs and motors (approx. 30 seconds)
Reset = Reset
Pan &
Tilt
Reset pan and tilt motors
Head = Reset the device head
All = Reset all motors and settings
linear
DMX value
Light intensity
exponential
DMX value
Light intensity
logarithmic
DMX value
Light intensity
S-curve
DMX value
Light intensity
DIMMER CURVES
DEVICE INFORMATION (System Info)
Press MODE to access the system settings selection menu. Now use UP and DOWN to select the menu item "System Info" (shaded in
colour) and confirm with ENTER. This will take you to the sub-menu for displaying the device information. Use UP and DOWN again to select
the required sub-menu item, then access the information with ENTER.
DMX 36 Ch
ADDRESS 001
MODE xxx
Setting
System Info DMX 36 Ch
Software Ver
VR.xx
Temp info
Time info