6
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
7
ZOOM
The calibration control for manually setting the beam angle is located on the right side of the housing. Directly opposite, on the housing, is
the yellow operating knob for manually setting the beam angle with the operating rod (when truss mounted). The calibration control and the
drive unit for an operating rod are mechanically connected. Turn the calibration control or yellow operating knob to adjust the beam angle
of the spotlight continuously. A rack and pinion system moves the zoom tube with the Fresnel lens in and out of the housing. The further the
zoom tube protrudes from the housing, the smaller the beam angle. A stop mechanism prevents the tube from becoming detached from the
housing.
PRESSURE EQUALIZATION ELEMENT
The spotlight features pressure equalization elements to keep as little condensation as possible from forming inside the enclosure.
NOTE:
The input and output connectors must be protected against splashing water in accordance with the protection rating IP65 by
correctly blanking them with the corresponding IP65 plugs or the rubber blanking caps.
OPERATION
TIPS
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: “Welcome to Cameo”,
the model name and the software version. After this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX input, the characters in the display will start
to flash.
• If no input is made within approximately 30 seconds, the currently activated mode is automatically shown in the display (main display).
MAIN DISPLAY
The main display shows the currently activated mode (in the example DMX mode with DMX start address 001).
DMX Address
001
SETTING DMX START ADDRESS (DMX ADDRESS)
Press the encoder to access the main menu. Rotate the encoder to select the menu item “DMX Address” (left arrow) and confirm by pushing the
encoder. You can now configure the DMX start address as required by rotating the encoder (the highest value depends on the selected DMX mode).
Confirm the entry by pushing the encoder. Select the arrow symbol at the top of the menu for “back” and push the encoder to return to the main
display. DMX mode is automatically activated when setting the DMX start address.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
DMX Address
001
001
5xx
–
