The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
Pa
g.
1
2
12
- M
an
u
al
c
od
e:
3
1
9
L
R
3
1
31
9
L
R
3
1
ve
r.
1
.0
1.
0
0
2
/2
0
0
9 © C
A
M
E c
an
ce
lli
auto
m
ati
ci
s.p.a.
ENGLISH
Programming the end-stop in the closing and opening phase
- Position dip-switch n°1 to ON (the programming signal led fl ashes).
Push and keep pressed the AP/CH switch until the door closes...
...then press the ENC/RADIO button until the signalling led stays on for some seconds and then resumes blinking (the program-
ming operation is satisfactorily complete).
Programming the end-stop in the closing phase
- Push and keep pressed the OPEN button until the door is fully open...
...then press the ENC/RADIO button until the signalling led stays on (the programming operations is satisfactorily complete).
Finally, set dip switch n°1 back to OFF.
Programming the end-stop in the opening phase
TEST
Use the AP/CH button to command both an opening and a closing to verify whether the programmino was successful.
Summary of Contents for ZL56A
Page 39: ......
