+
-
&).%!$*
!-03%.3
!-03%.3
3,/7$/7.
!-03%.3
/04)-%
!#4
$%,!9-
OP TIME
OP TIME
ENGLISH
P.
1111
-
M
an
u
al
c
od
e:
31
9
U
3
3
31
9
U
3
3
ve
r.
1.
0
1.
0
05
/2
0
11
© C
A
M
E c
an
ce
lli auto
m
ati
ci
s.p.a. - T
h
e d
ata a
n
d i
nf
or
m
ati
on
in
th
is
m
an
u
al
m
ay b
e c
h
an
g
ed at a
ny tim
e a
n
d w
ith
ou
t o
b
lig
ati
on
o
n th
e p
art of C
am
e C
an
ce
lli A
uto
m
ati
ci
S
.p.a. to n
otify s
ai
d c
h
an
g
es.
8 Settings
- END ADJ/SENS.
* End adjustement of amperometric sensor during travel:min/max.
- AMP SENS.
* Adusts the amperometric sensitivity which controls the force developed by the motor during
movement; if the force exceeds the adjusted level, the system intervenes and inverts the direction of
travel.
- SLOWDOWN/AMP SENS
* Adusts the amperometric sensitivity which controls the force developed by the motor during
movement; if the force exceeds the adjusted level, the system intervenes and inverts the direction of
travel.
- OP TIME
Adjusts the closing strike zone.
- ACT
Adjusts the waiting time when open.Once this time elapses, automatic closing is triggered.The waiting
time can be adjusted to between 2 and 120 seconds.
- DELAY 2M
Adjusting the M2 waiting time for each closing.The waiting time can be adjusted to between 1 and 15
seconds.
* Warning!: minimum sensitivity = maximum power
After setting the slowdowns (fi g. 3) with the "micro-switch adjusting" illustrated in the gearmotor manual ...
... prepare a 60 x 30 mm template and keep it rested against one of the two strike plates, as shown in fi g. 1 (you can adjust it either on
the closing or opening strike plates).
Activate the gate - with a command button or with the transmitter - and turn the OP TIME trimmer clockwise until the gatge leaf inverts
its direction of travel the moment it touches the obstacle/template.
Then turn the template from the short side (fi g. 2) and check that the gate lead stops by touching the obstacle/template.Otherwise turn
the trimmer counter-clockwise.
If you have a two-leaf gate, carry out the procedure on both gate leaves.
Adjusting the closing strike zone
fi g. 1
fi g. 3
A = Eff ective zone of the amperometric sensor
with movement inversion
B = Normal speed travel zone
C = Decelerated speed travel zone
D = Eff ective zone of the amperometric sensor
with movement stop
E = Closing and opening strike plates
fi g. 2
