1
2
1
2
Pa
g
e
6
- M
an
u
al
c
od
e:
11
9
G
3
7
8
2
E
N
11
9
G
3
7
8
2
E
N
ve
r.
1
1
0
1/
2
0
14 © C
A
M
E
c
an
ce
lli
auto
m
ati
ci
S
.p.
A
. - T
h
e d
ata a
n
d i
n
fo
rm
ati
on p
rovi
d
ed
in
th
is
m
an
u
al
a
re s
u
b
je
ct to c
h
an
g
e at a
ny ti
m
e w
ith
ou
t p
ri
or n
oti
ce
by C
A
M
E
C
an
ce
lli
A
u
to
m
ati
ci
S
.p.a.
Preliminary checks
Tools and materials
⚠
The following is necessary before installing the turnstile:
• If necessary, provide the corrugated tubing required for the passage of electrical cables;
• Provide a suitable omnipolar disconnector device, with a maximum of 3 mm between the contacts, to disconnect the power supply;
• Prepare suitable piping and ducts for routing the electrical cables, ensuring protection against mechanical damage;
•
Make sure that any connections within the container (made to ensure the continuity of the protection circuit) are fitted with additional insulation compared to
the other internal conductor parts;
Types of cables and minimum thicknesses
☞
If the cables differ in length from what is shown in the table, the cable cross-section is determined according to the actual current draw of the devices connected
and according to the provisions of the IEC EN 60204-1 standard.
For connections that require several, sequential loads, the sizes listed in the table must be re-evaluated based on actual power draw and distances. When connecting
products that are not specified in this manual, please refer to the documentation provided with said products.
Connection
Cable type
Cable length
1 < 10 m
Cable length
10 < 20 m
Cable length
20 < 30 m
230 V power supply control panel
FROR CEI 20-22
IEC EN
50267-2-1
3G x 1.5 mm
2
3G x 1.5 mm
2
3G x 1.5 mm
2
Accessory power supply
2 x 0.5 mm
2
2 x 0.5 mm
2
2 x 1 mm
2
Control and safety devices
2 x 0.5 mm
2
2 x 0.5 mm
2
2 x 0.5 mm
2
Make sure you have all the tools and materials needed for the installation at hand to work in
total safety and compliance with current standards and regulations. The figure shows some
examples of installer’s tools.
INSTALLATION
The following illustrations are only examples, given that the space for securing the turnstile and accessories varies depending on the overall dimensions. The
installation technician is responsible for choosing the most suitable solution.
⚠
The turnstile must be mounted by two people. Transport and lift using appropriate lifting equipment.
⚠
Risk of tipping over! Do not lean on the turnstile until it is fully secured.
Preparing the turnstile
Lift
and extract them
.
Remove the casing by unscrewing the fixing screws.
GENERAL INSTRUCTIONS FOR INSTALLATION
⚠
Installation must be carried out by qualified and experienced personnel in compliance with applicable regulations.
