Pa
g
e
2
- M
an
u
al
c
od
e:
11
9
G
3
7
8
2
E
N
11
9
G
3
7
8
2
E
N
ve
r.
1
1
0
1/
2
0
14 © C
A
M
E
c
an
ce
lli
auto
m
ati
ci
S
.p.
A
. - T
h
e d
ata a
n
d i
n
fo
rm
ati
on p
rovi
d
ed
in
th
is
m
an
u
al
a
re s
u
b
je
ct to c
h
an
g
e at a
ny ti
m
e w
ith
ou
t p
ri
or n
oti
ce
by C
A
M
E
C
an
ce
lli
A
u
to
m
ati
ci
S
.p.a.
Emergency button
CAUTION!
important personal safety instructions:
READ CAREFULLY!
Foreword
• This product should only be used for the purpose for which it was explicitly
designed. Any other use is considered dangerous. CAME Cancelli Automatici
S.p.A. will not be held liable for damage caused by improper, incorrect or
unreasonable use. • The safety of the product, and therefore its proper
installation, depends on total compliance with the technical specifi cations and
installation procedures, as well as with rules regarding safety and use, expressly
mentioned in the technical documentation for the products themselves. • Keep
these warnings together with the installation and operation manuals for the
operator system components.
Before installing
(preliminary check: in case of a negative outcome, do not proceed until you
have complied with the safety requirements)
• Installation and testing must only be performed by qualifi ed personnel •
Cable routing, installation, connection and testing must be carried out to
the highest levels of workmanship in accordance with applicable laws and
regulations • Before starting any operation, read all the instructions carefully;
incorrect installation can be dangerous and harm persons or property • Check
that the operator is in good mechanical condition, balanced and aligned, and
that it opens and closes properly. If needed, also install suitable guards or use
appropriate additional safety sensors • If the operator will be installed at a
height of less than 2.5 m from the ground or other access level, check whether
you will need any protections and/or warnings • Ensure that opening the
turnstile does not create a dangerous situation • Do not mount the operator
upside down or onto any elements that may fold under its weight. If needed,
add suitable reinforcements at the points where it is secured • Do not install on
ground that is not level • Check that any lawn watering devices will not wet the
operator from the bottom up.
Installation
• Carefully section off the entire site to prevent unauthorised access, especially
by minors and children • Be careful when handling operators that weigh more
than 20 kg. In such cases, use proper weight handling safety equipment •
CE safety devices (photocells, platforms, sensitive edges, emergency buttons
etc.) must be installed in compliance with applicable legislation and according
to the highest standards of workmanship, bearing in mind the environment,
the type of service required and the operating forces applied to the moving
turnstiles. Points where there is a risk of crushing, shearing or dragging must
be protected using suitable sensors • End users must be informed of any
residual risks by means of special pictograms as envisaged by legislation •
All opening commands (buttons, key selectors, magnetic readers etc.) must be
installed at least 1.85 m from the perimeter of the area of turnstile movement,
or where they cannot be reached from outside through the turnstile. Also,
the direct commands (buttons, touch commands etc.) must be installed at a
height of at least 1.5 m and must not be accessible to the public • The turnstile
identifi cation data must be clearly visible • Before connecting the turnstile to
the power supply, make sure the identifi cation data corresponds to the mains
data • The turnstile must be connected to an eff ective, compliant earthing
system • The manufacturer disclaims any liability for the use of non-original
products; this also results in the invalidation of the warranty • All ‘hold-to-
run’ commands must be placed where the moving turnstile, transit areas and
driveways are completely visible • Before delivery to the user, check that the
system complies with the EN 12453 and EN 12445 standards (impact tests),
check that the operator has been properly adjusted and that the safety and
protective devices work correctly • As appropriate and in a visible position, affi
x
warning symbols.
Special instructions and advice for users
• Keep the turnstile’s area of operation clean and clear of any obstacles. Check
that the photocells' area of operation is free from obstacles • Children must be
supervised to make sure they do not play with the operator and the fi xed control
devices or stand in the turnstile's area of operation. Keep any remote control
devices (i.e. transmitters) or any control devices away from children as well,
to prevent the operator from being activated accidentally • The operator is not
designed to be used by persons (including children) whose physical, sensorial
or mental capacities are limited, or who are lacking in experience or knowledge,
unless said persons can be supervised or given instructions regarding using the
operator by a person responsible for their safety • Frequently check the system,
to see whether any anomalies or signs of wear and tear appear on the moving
parts, on the component parts, on the securing points, on the cables and any
accessible connections. Keep any joints lubricated and clean, and do the same
where friction may occur • Perform functional tests on photocells every six
months. Ensure that the glass on the photocells is kept clean (use a cloth slightly
moistened with water; do not use solvents or any other chemicals as these
could damage the devices) • If the system requires repairs or modifi cations,
disconnect the power to the operator and do not use it until safety conditions
have been restored • Cut off the electrical power supply for manual opening.
Read the instructions • If the power cable is damaged, it must be replaced
by the manufacturer or the technical assistance service or by a person with a
similar qualifi cation so as to prevent any risks • It is STRICTLY FORBIDDEN for
users to perform OPERATIONS THEY ARE NOT EXPLICITLY REQUIRED AND ASKED
to do. For repairs, adjustments and extraordinary maintenance, CONTACT THE
SPECIALIST TECHNICAL SERVICE CENTRE • On the periodic maintenance log,
note down the checks you have done.
Further special instructions and advice for all
• Avoid working near the turnstiles or moving mechanical parts • Stay clear of
the turnstile's area of operation when in motion • Do not resist the direction
of movement of the operator; this may pose a safety hazard • At all times be
extremely careful about dangerous points that must be indicated by proper
pictograms and/or black and yellow stripes • When using a selector or
command in ‘hold-to-run’ mode, keep checking that there are no people in the
area of operation of the moving parts. Do this until you release the command
• The turnstile may move at any time without warning • Always cut the power
when cleaning or performing maintenance.
Danger of hand crushing
Danger - live parts
No transit during the manoeuvre
