CAME MTMA/01, Programming Manual

Page: 5 / 8

PROG
PROG
<1’’ <1’’
PROG
>20’’ >20’’
PROG
>8’’ >8’’
<11’’ <11’’
M
PROG PROG
>3’’ >3’’
1 P.E. 1 P.E. 1 P.E.
PROG
a a a a a a
Pa
ge
5
- M
an
ua
l
FA
01
47
9-
EN
- 0
7/
2
0
2
0 - © C
A
M
E S
.p.
A
. - T
he c
on
te
nt
s o
f t
hi
s m
an
ua
l m
ay b
e c
ha
ng
ed
, a
t a
ny t
im
e, a
nd w
ith
ou
t n
ot
ic
e. - T
ra
ns
la
tio
n o
f t
he
or
igin
al
ins
tr
uc
tio
ns
To enable the intercommunicating function, press the intercommunicating call button you want to call with on the internal receiver you
want to program
. A beep indicates that the function has been programmed successfully. Repeat for all of the other internal receivers
to be included in the intercommunicating group. To conclude programming, press the PROG button on the entry panel briefl y .
NOTE. Once an internal receiver has been included in a group by assigning the intercommunicating call button, it cannot be
excluded from this group. If you want to change the call button on an internal receiver which has already been programmed
as an intercommunicating receiver, or you want to add new internal receivers to the group, repeat the operations detailed
under “Programming an intercommunicating group”.
Enabling/disabling
Press the PROG button on the entry panel and hold for at least 20 seconds .
The red and yellow LEDs fl ash quickly for 3 seconds .
NOTE: If the intercommunicating function is disabled, follow this procedure to enable it, and vice versa.
The yellow LED comes on for 2 seconds to show the function has been enabled, or the red LED comes on for 2 seconds to show
the function has been disabled.
NOTE. Program the intercommunicating group after assigning calls to all indoor receivers.
Programming an intercommunicating group
Press and hold the PROG button on the entry panel for at least 8 seconds and release within 11 seconds .
The red and yellow LEDs fl ash to show intercom programming is in progress .
PROGRAMMING ENTRY PANELS WITH VA/01 OR A/01
Programming for the first time
Entering programming mode
Press the PROG button on the power supply until the PROG LED lights up.
The LEDs and and the button LEDs fl ash to show the buttons are being
programmed .